NF ZM2371 - Initialization

3.5 Basic Operations
3-25 ZM2371/ZM2372
3.5.4 Initialization
There are two types of initialization as described below.
 Initialization of current settings
_ SHIFT _ + [ INIT ]
Press the _ SHIFT _ + [INIT] keys to display the initialize menu, and press the _ 1 _ key, so
that currently used settings and correction values are reset to default values.
Upon initialization, the initialization completion message “Done” is displayed, and then
the measurement screen comes back.
Done
The contents of settings and correction value memories are not initialized.
If the EXIT operation is performed without pressing the _ 1 _ key, the measurement screen
comes back.
Only the settings cannot be initialized without initializing correction values. Save
necessary correction values in the correction value memory.
_ SHIFT _ _ 0 _ | [INIT]
 Full initialization
To reset all settings except operation modes to the factory default values, perform full
initialization. The contents of settings and correction value memories are also initialized.
For details  “4.10 Initializing all Settings”