NF ZM2371 - 5.4 Command List

5.4 Command List
5-15 ZM2371/ZM2372
5.4 Command List
ZM2371 / ZM2372 commands are separated into the common commands defined by
IEEE488.2 and subsystem commands that reflect device-specific functions.
The ZM2371 / ZM2372 has different command systems depending on the operation mode.
This section describes standard operation mode. For other operation modes, see “6. Change
of Operation Mode”.
Common commands that ZM2371 / ZM2372 provides are listed in Table 5-2. Also, subsystem
commands of ZM2371 / ZM2372 are listed in Table 5-3.
The meaning of codes used in Table 5-2 and Table 5-3 are explained below. It is possible to
omit the keywords lowercase character parts.
• Keywords shown in square brackets ([ ]) are those that support omission. (implicit
keyword)
• The vertical bar ( | ) indicates the possibility to select a keyword from several keywords.
Table 5–2 Common command list
Command
Name
Function
*CLS
Clear Staus Command
Clears status data
*ESE
*ESE?
Standard Event Status
Enable Command /
Query
Sets/queries the standard event status enable
register.
*ESR?
Standard Event Status
Register Query
Queries the standard event status register contents.
*IDN?
Identification Query
Queries the device identification information (model
name etc).
*OPC
*OPC?
Operation Complete
Command / Query
Requests to set the Standard Event Status register ’s
OPC bit to 1 when all command operations are
completed. In response to query, it returns 1 when
all operations are completed.
*OPT?
Option Identification
Query
Queries the built-in options.
*RCL
Recall Command
Recalls the contents of specified settings memory.
*RST
Reset Command
Resets the device and initializes the settings.
*SAV
Save Command
Saves current settings in the specified settings
memory.
*SRE
*SRE?
Service Request Enable
Command / Query
Sets/queries the service request enable register.
*STB?
Read Status Byte Query
Queries the status byte.
*TRG
Trigger Command
Applies a trigger to execute measurement once when
the trigger source is BUS and the device waits for a
trigger, and reads the measured data when
measurement finished.
*TST?
Self-Test Query
Queries the self test result.
“0” (no error) is returned, if normal.
*WAI
Wait-to-Continue
Command
Waits for executing the following commands until all
of the preceding command operations are completed.