NF ZM2371 - 4.3 Sorting the Part (Comparator)

4.3 Sorting the Part (Comparator)
4-6 ZM2371/ZM2372
4.3 Sorting the Part (Comparator)
For ZM2371 / ZM2372, up to 14 bins for primary parameter and one set range for secondary
parameter can be set to sort the comparator results.
However, comparison of BIN10-BIN14 is not conducted for ZM2371, so that the classified
number of primary parameter is up to 9.
 Limit comparison
The remote control allows the use of limit comparison function wherein sorting is done while
upper/lower limit (one set) of primary parameter and upper/lower limit (one set) of
secondary parameter are being set. The limit comparison function is not made into effect
through the panel.
Once the limit comparison function is made into effect, independent of the setting for Bin
sorting, comparison can be done only for one set (common to BIN1 for Bin sorting) of
upper/lower limit values of primary parameter and one set (common to secondary parameter
for Bin sorting) of upper/lower limit values of secondary parameter. In this case, the
comparison for Bin 2 to BIN14 is not conducted.
For detail, see the explanation for each command stated in the chapter 5 “5.6.3.2 Sub system
command”
:CALCulate:COMParator[:STATe] Command
:CALCulate1:LIMit Command tree
:CALCulate2:LIMit Command tree