NF ZM2371 - 1.3 List of Functions

1.3 List of Functions
1-3 ZM2371/ZM2372
1.3 List of Functions
The following shows the outline of functional tree of ZM2371 / ZM2372.
Measurement range (Manual, Auto)
Signal source Measurement frequency
Measurement signal level
ALC (constant voltage, constant current)
DC bias
Minimum output impedance
Triggered drive
Trigger Trigger source
Trigger (measurement start)
Trigger delay time
Measurement speed
Averaging
Correction Open
Short
Load
Cable length
Contact check (ZM2372 only)
Display/output Selection of parameter
Equivalent circuit (Manual, Auto)
Deviation display (format, reference value)
Selection of parameter
Deviation display (format, reference value)
Comparator Primary parameter comparison (Bin upper & lower limits, deviation)
Secondary parameter comparison (upper & lower limits)
Bin extension (~14, ZM2372 only)
Handler interface (ZM2372 only)
Beeper
Limit comparison Primary parameter comparison (upper & lower limits)
Secondary parameter comparison (upper & lower limits)
Auxiliary display (status, comparator upper & lower limits, reference value for judgment, IV monitor)
Buffer 1 (record data, size)
Buffer 2 (record data, size)
Buffer 3 (size)
Latest measured data
New measured data
Transfer format (ASCII, binary, pack format)
Interface USB
RS-232 (data rate, terminator, handshake)
GPIB (address, ZM2372 only)
Operation Key lock
Settings and correction value memory (save, recall)
Initialization
Operation mode
Measurement
conditions
Measurement
buffer
Measured value
reading
Measured value
display
Primary
parameters
Secondary
parameters