NF ZM2371 - Page 145

5.4 Command List
5-18 ZM2371/ZM2372
Table 5-3 Subsystem command list (3/3)
Command
Function / Operation target
SENSe subsystem (Continued)
[:SENSe][:FIMPedance]:APERture[:MODE]
Measurement speed /
measurement time
[:SENSe][:FIMPedance]:CONTact:VERify
Enables contact check 1
[:SENSe][:FIMPedance]:CONTact:RVERify
Enables real time check 1
[:SENSe][:FIMPedance]:RANGe:AUTO
Enables measurement range auto
switching
[:SENSe][:FIMPedance]:RANGe[:UPPer]
Measurement range
[:SENSe]:FRESistance:RANGe:AUTO
Enables Rdc measurement range
auto switching
[:SENSe]:FRESistance:RANGe[:UPPer]
Rdc measurement range
[:SENSe]:FUNCtion:CONCurrent
Enables execution of multiple
measurements
[:SENSe]:FUNCtion[:ON]
Specifies measurement function
SOURce subsystem
:SOURce:CURRent:ALC[:STATe]
Enables constant current drive
:SOURce:CURRent[:LEVel][:IMMediate][:AMPLitude]
Constant current level
:SOURce:FREQuency[:CW]
Measurement frequency
:SOURce:RESistance[:LIMit]:LOW
Minimum output impedance
:SOURce:VOLTage:ALC[:STATe]
Enables constant voltage drive
:SOURce:VOLTage[:LEVel][:IMMediate][:AMPLitude]
Measurement voltage level
:SOURce:VOLTage[:LEVel][:IMMediate]:OFFSet
DC bias voltage
:SOURce:VOLTage[:LEVel][:IMMediate]:OFFSet:STATe
Enables DC bias
:SOURce:VOLTage:MODE
Enables triggered drive
STATus subsystem
:STATus:OPERation:CONDition?
Queries the condition (OPCR)
:STATus:OPERation:ENABle
Enables an event (OPEE)
:STATus:OPERation[:EVENt]?
Queries an event (OPER)
SYSTem subsystem
:SYSTem:ERRor?
Queries the content of error
:SYSTem:KLOCk
Enables key lock
:SYSTem:MEMory
Selects settings / correction value
1
:SYSTem:RCL
Recalls settings / correction value
:SYSTem:SAVE
Saves settings / correction value
TRIGger subsystem
:TRIGger:SOURce
Trigger source
:TRIGger[:IMMediate]
Trigger (measurement start)
:TRIGger:DELay
Trigger delay time
1: Only for ZM2372. Unusable for ZM2371.