NF ZM2371 - Page 156

5.6 Command Explanation
5-29 ZM2371/ZM2372
:CALCulate:COMParator:BEEPer:CONDition {FAIL|PASS}
:CALCulate:COMParator:BEEPer:CONDition?
Description: Sets/queries whether the beeper sounds when the comparator result
does not fall in BIN1….BIN14 or when the result falls in the range.
To sound the beeper, enable the beeper by giving additionally
the :CALCulate:COMParator:BEEPer[:STATe] command.
Parameters: FAIL The beeper sounds when the comparator result is other than
BIN1…BIN14 (namely, OUT OF BINS, S-NG, ERR).
In the limit comparison, the beeper sounds when the
comparator result is not IN.
PASS The beeper sounds when the comparator result is within
BIN1…BIN14.
In the limit comparison, the beeper sounds when the
comparator result is IN.
Setting example: :CALC:COMP:BEEP:COND FAIL
Sets so that the beeper sounds when the comparator result does not fall
in BIN1 - BIN14.
Response: {FAIL|PASS}
Query example: :CALC:COMP:BEEP:COND?
Response example: FAIL
The beeper sounds when the comparator result does not fall in BIN1 -
BIN14.
:CALCulate:COMParator:BEEPer[:STATe] {ON|OFF|1|0}
:CALCulate:COMParator:BEEPer[:STATe]?
Description: Sets or queries whether the beeper is enabled or disabled.
If disabled, the beeper does not sound regardless of comparator result.
Parameters: {ON|1} Enables the beeper.
{OFF|0} Disables the beeper.
Setting example: :CALC:COMP:BEEP ON
Enables the beeper.
Response: {1|0}
Query example: :CALC:COMP:BEEP?
Response example: 1
The beeper is enabled.
:CALCulate:COMParator:CLEar
Description: Initializes the comparator setting.
For details • • •  “Table 4-1 Initialization contents of comparator”
Setting example: :CALC:COMP:CLE
Initialize the comparator setting.