5.6 Command Explanation
5-73 ZM2371/ZM2372
:SYSTem:MEMory {SETTing|CORRection|BOTH}
:SYSTem:MEMory?
Description: Sets/queries the target to be recalled from the memory through selection
line of handler interface.
Parameters: SETTing Settings (measurement conditions such as
frequency)
CORRection Correction values (OPEN, SHORT, LOAD)
BOTH Both settings and correction values
Setting example: :SYST:MEM CORR
Sets correction values as the target to be recalled.
Response: {SETT|CORR|BOTH}
Query example: :SYST:MEM?
Response example: CORR
The target to be recalled is correction values.
Remarks: This command is not supported by ZM2371. An error will occur.
:SYSTem:RCL <memory number>,{SETTing|CORRection|BOTH}
Description: Recalls the settings or correction values from the specified memory.
Parameters: <memory number> {numeric value, range 0 - 31}
Out of range value causes an error.
SETTing Recalls the settings (measurement conditions
such as frequency).
CORRection Recalls the correction values (OPEN, SHORT,
LOAD).
BOTH Recalls both settings and correction values.
Setting example: :SYST:RCL 2,BOTH
Recalls both settings and correction values from the memory number 2.
When only the correction values are recalled, the correction is not
turned on automatically.
:SYSTem:SAVE <memory number>,{SETTing|CORRection|BOTH}
Description: Saves the settings and correction values in the specified setting
/correction value memory.
Parameters: <memory number> {numeric value, range 0 - 31}
Out of range value causes an error.
SETTing Saves the settings (measurement conditions such
as frequency).
CORRection Saves the correction values (OPEN, SHORT,
LOAD).
BOTH Saves both settings and correction values.
Setting example: :SYST:SAVE 2,CORR
Saves the correction values in the memory number 2.
To Next Page
Loading...
