5.7 Status System
5-78 ZM2371/ZM2372
Related commands/ queries
*ESR?
Queries the contents of the standard event status register.
Cleared to 0 upon query. Can be cleared also by *CLS command.
Cleared to 0 upon powering on. However the PON bit is set to 1.
*ESE / *ESE?
Sets/queries the standard event status enable register.
Set to 0 to clear the enable register to 0.
Cannot be cleared by any other command.
Cleared to 0 upon powering on.
The parameter value of the setting message or response message to each register is the sum
of the weight of all the bits having 1 as the value.
To Next Page
Loading...
