5.7 Status System
5-81 ZM2371/ZM2372
Related commands/ queries
:STATus:OPERation:CONDition?
Queries the operation condition register contents.
The condition register contents is not cleared to 0 even if queried.
The device status is always indicated.
:STATus:OPERation[:EVENt]?
Queries operation event register.
The event register is cleared to 0 if queried.
The event register can also be cleared with a *CLS command.
Cleared to 0 upon powering on.
:STATus:OPERation:ENABle / STATus:OPERation:ENABle?
Sets/queries the operation event enable register.
Set to 0 to clear the enable register to 0.
Cannot be cleared by any other command.
Cleared to 0 upon powering on.
A parameter of each register setting message or response message takes a value that adds
up the weight of all bits set to 1.
To Next Page
Loading...
