Safety Precautions
iv ZM2371/ZM2372
Do not modify this product.
Absolutely never modify this product, as this may cause new hazards and may disqualify
this product from repair in case of failure.
Do not expose this product to water.
When this product is used in wet condition, it may cause an electric shock and a fire. If
this product is exposed to water, unplug the power cord immediately, and contact NF
Corporation or one of our representatives.
If lightning occurs, power off this product and unplug the power cord.
A lightning may cause an electric shock, a fire and a failure.
Safety-related symbols
The general definitions of the safety-related symbols used on this product and in the
instruction manual are provided below.
Instruction Manual Reference Symbol
This symbol is displayed to alert the user to potential danger and refer
him/her to the instruction manual.
Warning Symbol
This symbol indicates information for the avoidance of a hazard such as
electric shock that may endanger human life or cause serious injury
during handling of the equipment.
Caution Symbol
This symbol indicates information for minor or moderate injury, or
property damage to the equipment during handling.
Other Symbols
This symbol indicates the “on” position of the power swich.
This symbol indicates the “off” position of the power switch.
Shows when connected to the chassis.
──── Electromagnetic Compatibility ────
This product may cause interference if used in residential areas. Such use must be avoided
unless the user takes special measures to reduce electromagnetic emissions to prevent
interference to the reception of radio and television broadcasts.
──── Note on Waste Processing ────
To protect the environment, ensure that this device is disposed of by an appropriate industrial
waste processor. This product does not use batteries or a backlight that contains mercury.
To Next Page
Loading...
