NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 32
CHAPTER 2 MAINTENANCE
1 SERVICING
APRIL 15, 2012
Replacing the Neutral Start Switch
1.
container.
2. Move control lever to NEUTRAL position. Check to see that the switch
3. Install switch and tighten to 24 ft-lbs torque. Readjust switch.
NOTE: Be sure the switch packing is properly installed to prevent oil leakage.
4.
C-6 Transmission Set-Up Procedure for Diesel Engines
NOTE: If the transmission vacuum modulator pin comes out the pin must be
reinstalled into the transmission for the mechanical modulator to function. See
NOTICE! Unit is factory adjusted and disassembly of the modulator lid should
not be required. Disassembly could result in unequal of screws causing
gasket leakage and/or loss of the internal parts.
To Next Page
Loading...
