NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 6
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
4. If a new cone was installed onto pinion shaft, press a new inner cup into
5. If a new outer cone is to be installed onto pinion shaft, press a outer new
6. Install new dowel into bearing cage, if removed
7. Place bearing cage assembly over drive pinion and bearing cone assembly.
8. Press outer front bearing cone onto shaft.
9. Rotate cage several revolutions to assure normal bearing contact.
10 . Install thrust washer.
11 . Install and secure inner nut to 300 ft/lbs.
13 . Install outer nut and tighten to 300 ft/lbs.
16 . Place gasket into groove in face of pinion cage and apply #51 sealing
compound or equivalent.
17 . Install new oil seal.
disassembled, continue to 3.1.9.
3.1.9 Reassembly of Dierential
1. If disassembled, attach bevel gear to case half using capscrews, washers
and nuts. Tighten to 60-75 ft/lbs. torque.
2.
oil.
3.
gear-case assembly.
4.
half. Draw together using four washers and capscrews, equally spaced.
5.
6. Install remaining washers and capscrews and tighten to 85-115 ft/lbs. If
lock wire was not used, apply Loctite No. 277 or equivalent to threads prior
to assembly.
7.
To Next Page
Loading...
