NMC-WOLLARD 100 - Figure 1-24: Setting Popup Status

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 32
CHAPTER 5 MANUFACTURER’S INFORMATION
25
NexSysLink
®
2" Stand-Alone CAN Display Operation Manual  SAE J1939
© 2011 Beede Electrical Instrument Co., Inc.
• Setting Popups
Enabling popups allows the Fault, Warning and Alarm screens to appear when a when a System Fault,
Warning or Alarm condition occurs�
Figure 1-24: Setting Popup Status
Exit
Display
Popup-Disabled
Display
Popup-Enabled
Popup
Units-English
Scroll down to the Exit option and press the Enter switch or
wait 30 seconds for the last displayed CAN parameter to appear�
Pressing the Enter switch toggles the popup setting to
disabled� Press the Enter switch to toggle the units back
to enabled�
When the selection arrow cursor is placed next to the
Popup option, the name changes to Popup and the current
setting, i�e�, Popup-Enabled or Popup-Disabled�
Pressing the Enter switch toggles between the two settings�
The setting is automatically saved once changed�
From the Setup menu, scroll to place the selection arrow
cursor next to the Popup option, Main Menu-Setup-Popup�
CAN DISPLAY MANUAL
NOVEMBER 02, 2015