NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 19
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
6. Install drag link and grease the link.
7. Bleed the system according to 2-1 - 1.12.
8. Install steering column cover and pitman arm cover, if applicable.
3.10 POWER STEERING PUMP
Repair of the power steering pump is not recommended. If the pump does not
function properly or leaks, replace the entire unit. If the cap is broken, cracked or
leaks, replace the cap.
3.10.1 Removal
1. Disconnect hoses at steering pump and secure in raised position to prevent
contaminants.
2. Remove capscrews that allow power steering pump to pivot. Remove belt
and pump.
3. Remove pulley from pump shaft.
4. Remove capscrews and washers securing pump to pivot bracket.
5. Remove cap from pump.
3.10.2 Installation
1. Position pump-to-pivot bracket with capscrews and washers.
2. Install pulley-to-pump shaft.
3. Install capscrews that allow pump to pivot.
5. Uncap hoses and pump connections. Connect hoses to pump. Tighten
6. Bleed system as described in 2-1 - 1.12.
7. Install cap on power steering pump.
3.11 STEERING COLUMN ASSEMBLY
3.11.1 Removal
1. Disconnect external horn wire from under dash panel.
2. Remove rubber horn button from steering wheel by peeling it from plastic
horn base.
spring and seat assembly don’t pop out.
your hand under steering wheel while removing wheel because two carbon
brushes and a spring will fall out.
To Next Page
Loading...
