NMC-WOLLARD 100 - Figure 1-21: Setting Backlight Intensity

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 29
CHAPTER 5 MAUFACTURER’S INFORMATION
22
NexSysLink
®
2" Stand-Alone CAN Display Operation Manual  SAE J1939
© 2011 Beede Electrical Instrument Co., Inc.
• Backlight
The instrument oers two levels of illumination control; external lamp switch on and lamp switch o�
Backlight intensity is set using the Backlight option from the Setup Menu, Main Menu-Setup-Backlight�
Backlight intensity values range from 0 or o to 100% or maximum by increments of 10%�
• Lamp On & Lamp Off
Lamp On: The Lamp On function sets the backlight illumination brightness when pin 4 of the
instrument's 6 pin connector is wired to an external lamp switch and that switch is turned on�
Lamp O: The Lamp O function sets the backlight illumination brightness when no external lamp
switch is used or when an external lamp switch is wired to pin 4 of the instruments 6 pin connector
and the lamp switch is turned o� This feature allows users to turn on and control the instruments
backlighting independent of the vehicle's or equipment's light switch�
Note: Standard factory hardware conguration for the instrument uses Pin 4 of the 6 pin connector
to connect to an external lamp switch� Some factory congured instruments use pin 4 for serial data
communication to Beede NexSysLink® instruments� See "Stand-Alone and Master Node Congurations"
on page iv for more information�
Figure 1-21: Setting Backlight Intensity
Units
Backlight
Lamp Off 50%
Lamp On 70%
Units
Backlight
Once the Lamp O backlight intensity is set, the Backlight
option of the Setup menu appears.
Scroll down to exit the Setup Menu or wait 30 seconds for
the last displayed CAN parameter to appear.
After setting the Lamp On backlight intensity, the Lamp O
backlight intensity screen appears.
Use the Up and Down switches to increase or decrease
the Lamp O backlight intensity.
Press the Enter switch to accept the value.
Lamp On backlight intensity bar graph appears.
Use the Up and Down switches to increase or decrease
the Lamp On backlight intensity.
Press the Enter switch to accept the value.
From the Setup Menu place the selection arrow cursor next to
Backlight, Main Menu-Setup-Backlight, then press the
Enter switch to begin adjusting the LCD backlight intensity.
CAN DISPLAY MANUAL
NOVEMBER 02, 2015