EasyManua.ls Logo

NMC-WOLLARD 100 - Alternator; Drag Link; Installation; Removal

NMC-WOLLARD 100
848 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 27
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
3.14 DRAG LINK
The drag link is a rod that connects the steering gear unit pitman arm to the
left-hand front axle knuckle.
3.14.1 Removal
1. Remove cotter pins from ends of drag link.
2. Unscrew drag link plugs enough to free pitman arm and steering arm.
Remove drag link.
3.14.2 Installation
1. Position drag link so openings in ends engage balls on pitman arm and
steering arm.

3. Align holes in ends of drag link tube with holes in plugs and install cotter
pins to secure.
3.15 ALTERNATOR
The alternator requires no special care except to keep the drive belt properly
tensioned. It is not a user-repairable item.
If you suspect a problem with the alternator, most alternator problems can be
traced to one of the following causes:
• Battery or battery connection fault.
• Loose, dirty, or corroded alternator connections.
• Broken wires to alternator.
• Slipping drive belt.
NOTICE! When welding on the tractor, disconnect the battery to prevent damage
to the alternator.

Table of Contents

Related product manuals