NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 80
CHAPTER 5 MANUFACTURER’S INFORMATION
C-6 TRANSMISSION SERVICE
C-6 AUTOMATIC TRANSMISSION SERVICE
Removal and installation procedures are included in the event the transmission must be
replaced or sent to a specialized repair facility.
The Ford C6 transmission combines a torque converter with a two-speed, fully
automatic unit for transmitting engine torque to the drive axle via a driveshaft.
Maintenance is limited to changing the uid and lter at the recommended service
intervals and adjusting the linkage, intermediate band, and neutral start switch.
Malfunctions
Automatic transmission malfunctions may be caused by poor engine perfor mance or
improper transmission adjustments.
You should always begin by checking engine performance, then uid level and
condition, and gearshift cable adjustment.
If the problem exists after these checks and adjustments are completed,
remove unit from service and refer the transmission to a transmission repair facility.
If you ever notice unusual noises such as gear noise or grinding, a buzz or whine,
knocks, scraping, clicking, etc., remove the unit from service and refer it to a
transmission repair facility.
Towing the Unit
Tow the unit with the rear end picked up or with the drive shaft
disconnected or the transmission will be damaged.
IN AN EMERGENCY, the unit may be towed without lifting the wheels or discon necting
the drive shaft IF:
• Engine is running AND transmission is in neutral.
• Towing distance must be LESS THAN 1 MILE and travel speed LESS THAN 5 M.P.H.
IMPORTANT! Failure to follow these instructions will void the warranty.
JANUARY 31, 2007
To Next Page
Loading...
