NMC-WOLLARD 100 - Figure 1-28: Setting LCD Contrast

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 35
CHAPTER 5 MAUFACTURER’S INFORMATION
28
NexSysLink
®
2" Stand-Alone CAN Display Operation Manual  SAE J1939
© 2011 Beede Electrical Instrument Co., Inc.
• Set Contrast
Contrast sets the dierence between the white and black colors of the LCD�
Figure 1-28: Setting LCD Contrast
Exit
Video Mode
Contrast
Contrast 50%
Video Mode
Contrast
Contrast
1-Parameter
Trip Mode
Display
Scroll down to the Exit option and press the Enter switch or
wait 30 seconds for the last displayed CAN parameter to appear�
After setting the contrast value, the selection arrow cursor
appears next to the Contrast option of the Display Menu,
Main Menu-Setup-Display-Contrast�
The contrast adjustment screen appears�
Use the Up and Down switches to increase or decrease the
contrast percent� Press the Enter switch to accept the
displayed contrast value�
With the selection arrow cursor next to the Contrast option,
press the Enter switch to open the contrast adjustment
screen�
The rst two Display Menu functions appear� Scroll to place
the selection arrow cursor next to the Contrast option�
From the Setup Menu place the selection arrow cursor next to
the Display option, Main Menu-Setup-Display, then press
the Enter switch to view the Display menu functions�
CAN DISPLAY MANUAL
NOVEMBER 02, 2015