NMC-WOLLARD 100 - Figure 1-15: Menu Prompt Sequence with no Configured Alarms

NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 23
CHAPTER 5 MAUFACTURER’S INFORMATION
16
NexSysLink
®
2" Stand-Alone CAN Display Operation Manual  SAE J1939
© 2011 Beede Electrical Instrument Co., Inc.
• Adding an Alarm or Alarms
The Edit Alarms function is used to add CAN parameters for alarm notication�
Users may set up to 15 parameters for alarm notication�
The Edit Alarms menu screens dier if no alarms are set as compared to when previously congured
alarms exist� If no previously congured alarms exist, the Add Alarm menu option appears after
selecting Edit Alarms� If previously congured alarms exist, the congured alarms appear before the
Add Alarm menu option� To add an additional alarm when previously alarms exist, users must scroll
down thru all the previously congured alarms before reaching the Add Alarm menu option�
Figure 1-15: Menu Prompt Sequence with No Congured Alarms
Return
Add Alarm
Return
Edit Alarms
View Alarms
Alarms-Enabled
Mute Audio Alarm
Alarms
When no alarms exist, selecting Edit Alarms returns two
menu options, Add Alarm and Return�
Press the Enter switch to begin adding a CAN parameter
for alarm notication or select Return to bring back
the Edit Alarms menu option�
With the selection arrow cursor next to the Edit Alarms
option, press the Enter switch to begin editing alarms�
The Alarms Menu appears with the selection arrow
cursor next to the Alarms-Enabled or Disabled option�
Scroll down to place selection arrow cursor next to the
Edit Alarms option�
From the Main Menu, scroll to place the selection
arrow cursor next to the Alarms option�
Press the Enter switch to open Alarms Menu�
CAN DISPLAY MANUAL
NOVEMBER 02, 2015