NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 17
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
4. Drain cleaning solution from tank. Rinse and repeat steps 1-4.
5. Flush interior of tank with clean water and allow to air dry.
7. Inspect tank protectors for deterioration.
8. Inspect fuel tank for damage. Repair or replace tank as needed.
9. Check tank mounting straps for rust and corrosion.
10. Inspect elbows for damage.
3.8.3 Repair or Replacement
explosion, before servicing a fuel tank: Clean the tank thoroughly before
soldering or brazing. Fill tank with an inert gas such as carbon dioxide or
1. Repair tank by soldering or brazing if needed. Re-prime and paint any
repaired areas of tank.
2. Test any repair with wet soap lather. Place an air hose in tank and admit air.
By holding a rag around hose where it enters, a mild pressure will be built
up. If the repair is sound, no bubbles will appear.
3. Replace corroded or damaged cap or sending unit.
4. Replace protectors if they are damaged or deteriorated.
5. Replace straps if weakened by either of these conditions.
6. Replace damaged parts.
7. If there is any doubt as to the integrity of the tank, replace the tank.
3.8.4 Reassembly
1. Install new gasket on sending unit opening on tank, then carefully lower
sending unit into tank. Do not use gasket cement.
2. Secure sending unit with its hardware.
installing tank.
4. Apply thread sealer to drain plug threads and install drain plug.
To Next Page
Loading...
