NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 14
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
3.7 TRANSMISSION AND TORQUE CONVERTER INSTALLATION
1. Tighten converter drain plug to 18-28 ft-lbs.
engaged in pump gear.
3. With converter properly installed, place transmission on jack. Secure
transmission to jack with chain and place under tractor.
4. Raise transmission to align with engine.
NOTE
6. Install the crankshaft adapter (1) to the engine crankshaft.
7. Bolt the (2) to the crankshaft adapter.
8. Bolt the torque converter adapter (4) to the transmission.
align the two housings properly by use of the locating dowel pins. Tighten bolts.
NOTICE! The engine and transmission must be assembled to each other before
bolting the engine to the torque converter adapter.
FIGURE 3. ENGINE/AT545 INSTALLATION
To Next Page
Loading...
