NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 15
CHAPTER 2 MAINTENANCE
10. Working through the access opening in the engine bell housing, bolt the (2) to
blue loctite and torque to 101-105 ft-lbs
11.
illustrated. Apply blue loctite to M10 x 1 x 85-12g bolt threads (6) and torque to
30 NM + 60° + 90°.
12. Align the studs of the torque converter through holes in the and assemble the
housings properly by use of the locating dowel pins. Tighten bolts.
13. Working through the access opening in the engine bell housing, Bolt the (2) to
blue loctite and torque to 101-105 ft-lbs.
14. Remove transmission jack safety chain from around transmission.
15. Position transmission support cross member to frame side rails and tighten
16. Position transmission rear support and insulator assembly above cross member
and lower transmission into place. Install mounting bolts and tighten to torque
17. Remove jack.
18. Connect vacuum line to vacuum diaphragm making sure that line is in retaining
clip.
19. Connect oil cooler lines to transmission.
20. Connect downshift and manual linkage rods or cable controls to their respective
levers on the transmission. Refer to parts illustrations in Chapter 4.
21. Secure starter motor in place with attaching bolts. Connect cable to terminal on
starter.
22.
case.
23.
24. Install converter housing access cover and secure it with attaching bolts.
25. Slide forward and connect it to transmission park brake drum. Connect park
brake cable to park brake lever.
26. Adjust shift cable as required. Refer to 2-1 - 1.9.3.
27.
procedures in 2-1 - 1.9.3. Check for leaks.
28. Connect neutral switch wire to plug connector.
29. Connect temperature sender wire.
30. Connect the battery negative cable.
31. Lower tractor. Start engine and again check for leaks.
AUGUST 31, 2008
3 REMOVAL AND INSTALLATION
To Next Page
Loading...
