NMC-WOLLARD 2021Truax Blvd., Eau Claire, WI 54703, Phone (715) 835-3151, Fax (715) 835-6625
M100 Tow Tractor Manual No. 46052
PAGE 18
CHAPTER 2 MAINTENANCE
3 REMOVAL AND INSTALLATION
AUGUST 31, 2008
3.8.5 Installation
1. When ready to install tank, place a quart of fuel in the tank, slosh around,
and pour out.
2. Install hoses and sending unit wire.
3. Position tank under frame and raise into position.
4. Install tank supports and straps. Tighten mounting hardware to 30 ft-lbs
torque.
5. Install battery and connect battery cables.
6. Fill tank with fuel and check for leaks.
3.9 STEERING GEAR ASSEMBLY
personnel. If the steering gear does not operate properly, replace it or take it to a
specialized repair shop.
3.9.1 Removal
1. Loosen hose clamp at power steering pump and disconnect hose. Drain
2. Remove steering column cover and pitman arm cover, if applicable.
4. Loosen pinch bolt on coupling on lower end of steering column.
5. Disconnect drag link at steering gear end.
6. Remove pitman arm nut and washer. Remove arm from steering gear.
7. Remove capscrews and washers securing steering gear to frame mounting
bracket. Disconnect steering gear from coupling on column and remove
from vehicle.
3.9.2 Installation
1. Position steering gear assembly on frame bracket and engage gear
shaft with coupling on lower end of steering column. Secure to bracket with
capscrews and washers. Tighten capscrews to 45 ft./lbs.
2. Tighten pinch bolt on steering gear coupling.
to power steering pump.
hose clamps.
5. Install pitman arm on gear shaft. Install hex nut and washer. Tighten hex
nut to 188 ft./lbs.
To Next Page
Loading...
