Network QoS Policies
188
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
dot1p
Syntax dot1p dot1p-priority queue queue-id profile {in | out}
no dot1p dot1p-priority
Context config>qos>network>ring
Description This command creates a mapping between the dot1p bits of the ingress traffic and the queue
and profile state. A maximum of eight dot1p entries are allowed on a single policy.
The no form of the command removes the association of the dot1p bit value with the queue
and profile state. The default-action then applies to that dot1p bit pattern.
Default 0
Parameters dot1p-priority — specifies the dot1p bit value to be associated with the queue and the
profile state
Values 0 to 7
Default n/a
queue-id — specifies the queue in which all packets with the dot1p bits value are placed
Values 1 to 8
Default 1
profile {in | out} — specifies the profile state of packets with the dot1p bit value, either
in-profile or out-of-profile
Values in, out
Default out
To Next Page
Loading...
