Quality of Service Guide Network QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 189
4.4.2.1.6 Network Egress QoS Policy Forwarding Class Commands
dot1p
Syntax dot1p dot1p-priority
no dot1p
Context config>qos>network>egress>fc
Description This command explicitly defines the egress dot1p priority bits values for the forwarding class.
The no form of the command sets the dot1p priority bits value to 0.
Default 0
Parameters dot1p-priority — the explicit dot1p value for the specified forwarding class. Setting the
value to 0 is equivalent to removing the marking value.
Values 0 to 7
Default n/a
dot1p-in-profile
Syntax dot1p-in-profile dot1p-priority
no dot1p-in-profile
Context config>qos>network>egress>fc
Description This command specifies dot1p in-profile mappings.
The no form of the command reverts to the factory default in-profile dot1p-priority setting for
policy-id 1.
Parameters dot1p-priority — defines the dot1p marking for the forwarding class
A maximum of eight dot1p rules are allowed on a single policy.
Values 0 to 7
Note: When a single dot1p-priority is specified, it is applied to both in-profile and
out-of-profile packets. The other forms of the command described below (dot1p-in-profile
and dot1p-out-profile) allow different dot1p values for in-profile or out-of-profile packets to
be specified.
To Next Page
Loading...
