Network QoS Policies
208
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
Parameters app-name — the specified application
Values arp, bgp, dhcp, dns, ftp, icmp, igmp, isis, ldp, mld, ndis, ntp, ospf,
pim, ptp, radius, rip, rsvp, snmp, snmp-notification, ssh, syslog,
tacplus, telnet, tftp, traceroute, vrrp
dscp — specifies to show all DSCP applications
dot1p — specifies to show all dot1p applications
Output The following output is an example of application QoS information, and Table 36 describes
the fields.
Output Example
A:ALU-1# show router sgt-qos application
===============================================================================
DSCP Application Values
===============================================================================
Application DSCP Value Default DSCP Value
-------------------------------------------------------------------------------
bgp none none
dhcp none none
dns nc2 none
ftp none none
icmp none none
igmp none none
ldp none none
mld none none
ndis none none
ntp none none
ospf none none
pim none none
radius none none
rsvp none none
snmp none none
snmp-notification none none
ssh none none
syslog none none
tacplus none none
telnet be none
tftp none none
traceroute none none
vrrp none none
===============================================================================
Note:
• PTP in the context of SGT QoS is defined as Precision Timing Protocol and is an
application in the 7705 SAR. The PTP application name is also used in areas such as
event-control and logging. Precision Timing Protocol is defined in IEEE 1588-2008.
• PTP in the context of IP filters is defined as Performance Transparency Protocol. IP
protocols can be used as IP filter match criteria; the match is made on the 8-bit protocol
field in the IP header.
To Next Page
Loading...
