Nokia 7705 - Page 295

Quality of Service Guide Service Egress and Ingress QoS Policies
Edition: 01 3HE 11014 AAAC TQZZA 295
6.4.2.1.3 Service Egress QoS Policy Forwarding Class Commands
dot1p
Syntax dot1p {dot1p-value | in-profile dot1p-value out-profile dot1p-value}
no dot1p
Context config>qos>sap-egress>fc
Description This command explicitly defines the egress dot1p priority bits values for the forwarding class.
The no form of the command sets the dot1p priority bits value to 0.
Default 0
Parameters dot1p-value — the explicit dot1p value for the specified forwarding class. Setting the
value to 0 is equivalent to removing the marking value.
Values 0 to 7
Values n/a
in-profile dot1p-value — the dot1p in-profile mapping for the specified forwarding class.
Setting the value to 0 is equivalent to removing the mapping value.
Values 0 to 7
Default n/a
out-profile dot1p-value — the dot1p out-profile mapping for the specified forwarding
class. Setting the value to 0 is equivalent to removing the mapping value.
Values 0 to 7
Default n/a
Note:
• When the dot1p dot1p-value command is used, the value is applied to both in-profile
and out-of-profile packets. When the dot1p in-profile dot1p-value out-profile dot1p-
value form is used, different dot1p values for in-profile or out-of-profile packets can be
specified.
• For QinQ applications, the top and bottom dot1p bits or top-only dot1p bits are set
based on the qinq-mark-top-only configuration. For more information, refer to the
command description and the “QinQ Top-Only Mark Option” section in the
7705 SAR Services Guide.