Nokia 7705 - Page 296

Service Egress and Ingress QoS Policies
296
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
dscp
Syntax dscp dscp-name
dscp in-profile dscp-name out-profile dscp-name
no dscp
Context config>qos>sap-egress>fc
Description This command defines the DSCP name or DSCP priority bits mapping for the forwarding
class.
Access IP traffic (that is, VPRN and IES access interfaces) will always be re-marked if the
interfaces are configured as part of the SAP egress QoS policy.
The no form of the command removes the DSCP mapping associated with the forwarding
class.
Default n/a
Parameters dscp-name — a system-defined, case-sensitive name
Values A maximum of 64 DSCP rules are allowed on a single policy. The
specified name must exist as a dscp-name. Table 46 lists all the
valid DSCP names.
in-profile dscp-name — the DSCP in-profile mapping for the specified forwarding class
Values any name listed in Table 46
out-profile dscp-name — the DSCP out-profile mapping for the specified forwarding
class
Values any name listed in Table 46
Note: When the dscp dscp-name command is used, the dscp-name is applied to all packets
regardless of the profile state. The in-profile and out-profile form of the command allows
differentiated values to be applied to packets based on the profile state.
Table 46 Valid DSCP Names
dscp-name
be, cp1, cp2, cp3, cp4, cp5, cp6, cp7, cs1, cp9, af11, cp11, af12, cp13, af13, cp15, cs2,
cp17, af21, cp19, af22, cp21, af23, cp23, cs3, cp25, af31, cp27, af32, cp29, af33, cp31,
cs4, cp33, af41, cp35, af42, cp37, af43, cp39, cs5, cp41, cp42, cp43, cp44, cp45, ef, cp47,
nc1, cp49, cp50, cp51, cp52, cp53, cp54, cp55, nc2, cp57, cp58, cp59, cp60, cp61, cp62,
cp63