Service Egress and Ingress QoS Policies
300
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
Description This command enables the context to configure an MC-MLPPP SAP egress policy queue.
Explicit definition of an egress queue’s hardware scheduler status is supported. A single
egress queue allows support for multiple forwarding classes.
The no form of the command removes the queue-id from the MC-MLPPP SAP egress policy.
Removing the queue-id also removes it from any existing SAPs using the policy. If any
forwarding classes are mapped to the queue, they revert to the default queue.
When a queue is removed, pending accounting information for each SAP egress queue
created due to the definition of the queue in the policy is discarded.
Default n/a
Parameters queue-id — the queue-id for the MC-MLPPP SAP egress queue, expressed as a
decimal integer. The queue-id uniquely identifies the queue within the policy.
Values 1 to 8
create — keyword used to create the context to configure an MC-MLPPP SAP egress
policy queue
scope
Syntax scope {exclusive | template}
no scope
Context config>qos>mc-mlppp>sap-egress
Description This command is used to enter the scope of the policy. The scope of the policy cannot be
changed if the policy is applied to one or more services.
The no form of this command sets the scope of the policy to the default of template.
Default template
Parameters exclusive — when the scope of a policy is defined as exclusive, the policy can only be
applied to a single SAP. Attempting to assign the policy to a second SAP will result
in an error message. If the policy is removed from the exclusive SAP, it will become
available for assignment to another exclusive SAP.
template — when the scope of a policy is defined as template, the policy can be applied
to multiple SAPs
To Next Page
Loading...
