Service Egress and Ingress QoS Policies
328
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
PIR Rule min - the operational PIR for the queue will be equal to or greater
than the administrative rate specified using the rate command
max - the operational PIR for the queue will be equal to or less
than the administrative rate specified using the rate command
closest - the operational PIR for the queue will be the rate closest
to the rate specified using the rate command
CBS def - the CBS value reserved for the queue
value - the value to override the default reserved buffers for the
queue
MBS def - the MBS value reserved for the queue
value - the value to override the default maximum size for the
queue
HiPrio The percentage of buffer space for the queue, used exclusively
by high-priority packets
Packet Offset The value of the packet byte offset applied to the queue.
A value of “default” indicates that legacy mode packet scheduling
is in use, in which packets are scheduled based on size including
internal overhead.
Slope-Policy The slope policy for the queue
FC Name The override for the forwarding class value
Queue-id The queue-id that uniquely identifies the queue within the policy
Dot1p The egress dot1p priority bits values for the forwarding class
Explicit/Default Explicit - the egress IEEE 802.1P (dot1p) bits marking for fc-
name
Default - the default dot1p value (0) is used
DSCP The DSCP name for the forwarding class
Marking The DSCP priority bits mapping for the forwarding class
Table 47 SAP Egress Command Output (Continued)
Label Description
To Next Page
Loading...
