Security Queue QoS Policies
474
Quality of Service Guide
3HE 11014 AAAC TQZZA Edition: 01
queue
Syntax [no] queue queue-id
Context config>qos>security-queue
Description This command enables the context to configure parameters related to the queue type for the
traffic extracted from the datapath to the CSM. When the security queue policy is created, a
set of queues is automatically created: queue 1 for best-effort traffic and queue 2 for
expedited traffic. When the best-effort and expedited queues are created, default values are
assigned to their information rate parameters.
The no form of this command removes the queue-id from the security queue policy.
Default n/a
Parameters queue-id — specifies the ID for the queue type being referenced
Values 1 for best effort queue
Values 2 for expedited queue
cbs
Syntax cbs {size-in-kbytes | default}
no cbs
Context config>qos>security-queue>queue
Description This command overrides the default Committed Buffer Space (CBS) reserved for the
specified queue. The value is configured in kilobytes.
The no form of this command returns the CBS to the default value for the queue type.
Parameters size-in-kbytes — specifies the committed buffer space for the queue
Values 1 to 131072 | default
Default 10 kbytes for best effort
40 kbytes for expedite
high-prio-only
Syntax high-prio-only {percent | default}
no high-prio-only
Context config>qos>security-queue>queue
Description This command configures the percentage of the queue used exclusively by high-priority
packets. The specified value overrides the default value for the queue type.
To Next Page
Loading...
