Nord Drivesystems B 1050 Series User Manual

Industrial gear units – Operating and Assembly Instructions
50 B 1050 en-1819
Information
Assembly
Use the end thread of the shafts for pulling. Assembly is facilitated by coating the hub with lubricant or heating it
up to approx. 100 °C beforehand.
Figure 21: Example of a simple pulling device
Pos: 97 /A nl eitu nge n/G etr iebe /3. Mont ag e, L ager ung , V orb erei tung , Aufs tell ung /Na ben auf Getriebewellen_04 [B1050] @ 30\mod_1552980686188_388.docx @ 2511533 @ @ 1
Drive and driven elements must only apply forces which were considered in the design of the
gear unit.
Observe the correct tension, particularly on belts and chains.
Additional loads due to unbalanced hubs are not permitted.
Pos: 98 /A llg em ein/ Allg em eing ülti ge M od ule/ ---------Seite numbruc h kom pakt --------- @ 13\ mod_1476369695906_0.docx @ 2265495 @ @ 1

Nord Drivesystems B 1050 Series Specifications

General

Brand	Nord Drivesystems
Model	B 1050 Series
Category	Engine
Language	English