Nord Drivesystems B 1050 Series User Manual

5 Service and maintenance
B 1050 en-1819 77
Pos: 186 /Anleitungen/Getriebe/5. Inspektion und Wartung/Ölfilter_01 [B1050, B2050] @ 29\mod_1551780537593_388.docx @ 2496915 @ 3 @ 1
5.2.10 Oil filter (Option: CS1-X, CS2-X, LC/LCX)
Pos: 18 7 /Anlei tung en/G etrieb e/5. In spekti on un d Wartu ng/Ölfi lter_ 02 [B 1050] @ 31\ mod_1553070756927_388.docx @ 2514845 @ @ 1
NOTICE!
Gear unit damage
The separate filter manufacturer’s documentation must be observed.
Pos: 18 8 /Anlei tung en/G etrieb e/5. In spekti on un d Wartu ng/Ölfi lter_ 03 [B 1050, B2050] @ 31\mod_1553070770807_388.docx @ 2514882 @ @ 1
As standard, the oil filter is equipped with a visual contamination indicator. It is recommended that the
filter element is replaced at the latest after an operating period of one year.
The filter element must be replaced immediately if the contamination indicator triggers. Refer to the
relevant manufacturer's documentation for further information.
Pos: 18 9 /Anlei tung en/G etrieb e/5. In spekti on un d Wartu ng/Lag er im Abtr iebsf lans ch [B10 50_B 2050] @ 28\mod _1551358114787_388.docx @ 2492871 @ 3 @ 1
5.2.11 Bearings is the output flange (Option: VL2/3/4/6, KL2/3/4/6)
For agitator version gear units, re-lubrication of the bearing in the output flange is necessary. Before
re-lubrication, the grease nipple opposite to the sealing plug must be unscrewed. Grease should be
injected until a quantity of 25 g escapes from the sealing plug. After this, the sealing plug must be
reinserted and tightened. Remove excess grease.
Recommended grease: Petamo GHY 133N - Klüber Lubrication (7.3.1 "Roller bearing greases").
Pos: 19 0 /Allgemein/Allgemeingültige Module/---------Seitenu mbruc h komp akt --------- @ 13\mod_1476369695906_0.docx @ 2265495 @ @ 1

Nord Drivesystems B 1050 Series Specifications

General

Brand	Nord Drivesystems
Model	B 1050 Series
Category	Engine
Language	English