Nord Drivesystems B 1050 Series User Manual

5 Service and maintenance
B 1050 en-1819 71
Pos: 15 7 /Anlei tung en/G etrieb e/5. In spekti on un d Wartu ng/Sic htko ntrolle [B1050_B2050] @ 17\mod_1493116655168_388.docx @ 2342970 @ 3 @ 1
5.2.1 Visual inspection
The gear unit must be checked for leaks. Attention should be paid to escaping gear oil and traces of
oil on the exterior or underneath the gear unit. In particular, the radial seals, cover caps, screw plugs,
hoses and housing joints should be checked.
If leaks are suspected, the gear unit should be cleaned, the oil level checked (5.2.6 "Oil level") and
checked again for leaks after approx. 24 hours. If a leak is confirmed (dripped oil), the gear unit must
be repaired immediately. Please contact the NORD Service department.
Information
Shaft sealing rings
Shaft sealing rings are rubbing seals and have sealing lips made from an elastomer material. These sealing lips
are lubricated with a special grease at the factory. This reduces the wear due to their function and ensures a long
service life. An oil film in the region of the rubbing sealing lip is therefore normal and is not due to leakage.
Pos: 158 /Anleitungen/Getriebe/5. Inspektion und Wartung/Laufgeräusche [B1050_B2050] @ 17\mod_1493116809037_388.docx @ 2343006 @ 3 @ 1
5.2.2 Running noises
If the gear unit produces unusual running noises and/or vibrations, this could indicate damage to the
gear unit. In this case the gear unit must be repaired immediately. Please contact the NORD Service
department.
Pos: 159 /A nleit unge n/Getri ebe/ 5. Insp ektion und War tung/G etrie bek ühlung üb er Lüft er_(I nspe ktion u nd Wart ung) [B 1050_ B2050 ] @ 17\mod_1493119196580_388.docx @ 2343042 @ 3 @ 1
5.2.3 Gear unit cooling with fan (Option: FAN)
The inlet and outlet openings on the fan cover and the fan wheel must be kept clean.
Before re-commissioning, observe the information in Section 4.4 "Gear unit cooling with fan( Option:
FAN)".
Pos: 16 0 /Anlei tung en/G etrieb e/5. In spekti on un d Wartu ng/ Wär met ausch er [ B1 050 _B2 050] @ 1 7\mod_1493119378825_388.docx @ 2343078 @ 3 @ 1
5.2.4 Heat exchanger (Option CS2)
The heat exchanger of the oil/air cooling unit must be cleaned regularly in order to preserve the
efficiency of the unit.
Pos: 16 1 /Allg emein/ Allg emeing ültig e Mod ule/---------Sei tenumbr uch ko mpakt --------- @ 13\mod_1476369695906_0.docx @ 2265495 @ @ 1

Nord Drivesystems B 1050 Series Specifications

General

Brand	Nord Drivesystems
Model	B 1050 Series
Category	Engine
Language	English