7 Appendix
B 1050 en-1819 99
7.3.2 Types of lubricant oil
Pos: 22 2 /Anlei tung en/G etrieb e/7. A nhang /Sch mierölar ten_ 03 [B1 050, B2 050] @ 3 2\mod_1553091393892_388.docx @ 2517071 @ @ 1
NOTICE! Gear unit damage
Failure to comply with this will result in damage to the gear unit.
• When changing oil or filling for the first time, the type of lubricant stated on the type plate must be used.
• The minimum permissible oil bath temperatures depend on the type of lubrication which is used. These
temperatures are stated in catalogue G1050.
• Additives and/or solid lubricants (corrosion inhibitors) may not be added to the stated lubricant without testing
or approval by Getriebebau NORD.
• Mixing of gear oil and roller bearing grease must not occur.
• Do not expose the gear unit to harmful influences such as aggressive chemical products.
The following table assigns the type of gear oil stated on the type plate (3.5 "Checking the type plate
data") to the particular approved product and the manufacturer.
If different oil types are mixed, damage to the gear unit is possible due to inadequate lubrication
through oil incompatibility.
Fill the gear unit with the previously used oil type. Mixing of oils of various types or from different
manufacturers is not permissible. In particular, polyglycol oils must not be mixed with mineral oils or
other synthetic oils. If the oil type is changed, thoroughly flush the gear unit with the new oil type
before filling. Use the new oil type for this.
Getriebebau NORD must be consulted in case of change of viscosity or lubricant type, as otherwise
no warranty for the functionality of our gearboxes can otherwise be accepted.
To Next Page
Loading...
Need help?
General
