Changing the IP address causes the
IPC to boot
192.168.0.99
255.255.255.0
IPC IP-adress
Subnet mask
Operation
4-57
P/N 7105144G
2008 Nordson Corporation
VersaBlue_NW
IP Address Setup
These settings are needed to communicate with the IPC when using the
Webserver. They must be clearly defined in an EtherNet network.
IPC IP-address: 192.168.0.99
Subnet mask: 255.255.255.0
Fig. 4-71 V21a
Example: Setting IP Addresses in a Network
All Nordson melters are delivered with the same IPC IP address. To be able
to work together in a network, every device, including a PC, must be
assigned its own IP address (Fig. 4-72).
The subnet mask mentioned above allows changes to be made to the last
part (host of melter part) of the IP address.
NOTE: All IP addresses ending with 1 to 254 are possible. IP addresses
ending with 0 or 255 are not permitted.
PC IP address:
192.168.0.98
IPC IP address:
192.168.0.99
Change to IPC
IP address:
192.168.0.100
IPC IP address:
192.168.0.99
IPC IP address:
192.168.0.99
Change to IPC
IP address:
192.168.0.101
Fig. 9-72 IP addresses in a network −Example−
To Next Page
Loading...
Need help?
General
