215
.
System maintenance
Navigation
This chapter contains information to help you perform system
maintenance, such as replacing DECT Access Points (DAP) and
managing DAP synchronization.
•
“DAP LED indications” (page 215)
•
“Remove and replace a DAP (if a new DAP is available)” (page 217)
•
“Remove and replace a DAP (if a new DAP is not available at the
moment)” (page 218)
•
“System synchronization analysis ” (page 219)
•
“Export and import SIP DECT system” (page 228)
• “DAP Controller deactivation” (page 230)
•
“DAP Controller software deinstallation” (page 230)
•
“DAP Controller software update” (page 231)
•
“Troubleshooting” (page 232)
• “If you have problems” (page 236)
DAP LED indications
The DAP is equipped with one LED. The LED can indicate 6 different
statuses of the DAP. The following indications may occur.
• Off No power.
• 0,5 seconds On - 0,5 seconds Off Loading software/firmware.
• Short flash every 0,25 seconds IP Network error (not connected, no
DHCP/TFTP server, no DAP Controller)
• Fast blink DAP operational, but trying to synchronize to another DAP.
• Continuous fast blink Hardware error.
• Steady On DAP operational (and synchronized to other DAP or is the
synchronization master).
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
