130 Software requirements
8 Ensure that the DHCP server is running and that the TFTP
server is running.
9 Reboot the DAPs. The IP data and configuration data is now
stored into the DAPs and the DAPs can function without the
DHCP and TFTP servers.
--End--
DAP Controller
Use the information in this section to install the DAP Controller from the
CD. You only need to execute this procedure once because the installation
can be used for as many system configurations as you want. Changing
settings can be always be done later.
Prerequisites
• Install and configure IIS software.
For more information, see “Internet information services” (page 105).
•
Install and configure DHCP and TFTP servers if you are using MS
Windows DHCP and TFTP servers. For more information, see “DHCP
and TFTP servers” (page 111).
•
Ensure that you have DAP controller or manager software, Release 4
or later.
•
Ensure that you have DAP firmware 4910c4xx.dwl or later.
•
Ensure that you have configured the IP addressing on the network
adaptor.
Procedure 45
Installing the DAP Controller
Step Action
1 Insert the CD-ROM in the CD drive and run setup.exe.
Depending on the directory structure on the CD-ROM, the
setup.exe file is found in the directory Disk1. The InstallShield
Wizard appears. This window remains visible during the
installation of the DAP controller components and gives you
information about the installation progress.
If Microsoft .NET Framework 1.1 is already installed, the
Welcome to the InstallShield Wizard for DAP controller
window appears. Go to step 6.
If the Microsoft .NET Framework 1.1 software is not yet installed,
an Installshield dialog appears, with the following statement:
DAP Controller optionally uses the Microsoft (R)
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
