218 System maintenance
Replacing a DAP
Step Action
1 Ensure that DAP Manager is running before you begin to replace
a DAP.
2 Ensure that the DHCP server and the TFTP server are running
in the IP network.
3 Open the DECT Manager WEB interface.
4 Click Access Points.
5 Disconnect the DAP that needs to be replaced.
Do not continue this procedure until DECT Manager indicates
that the DAP is not working.
6 Connect the new DAP.
Wait until you see that the new DAP is running (in the DECT
Manager interface).
7 Click the Edit button for the new DAP.
8 Change the RPN number of the new DAP to the RPN number of
the replaced DAP and click OK.
The new DAP reboots. When the DAP is running again, it has
the RPN of the replaced DAP. Now the subscriptions that were
active in the replaced DAP are automatically installed in the new
DAP. This can take a few minutes.
9 Check that the subscriptions of the replaced DAP are on the new
DAP.
Note: After the subscription records are placed in the new
DAP, switch the handsets associated with these records off
and on to make them operational again.
10 Check that you can make phone calls using the new DAP.
--End--
Remove and replace a DAP (if a new DAP is not available at the
moment)
Use the procedures in this section to replace a DAP that has failed.
Procedure 111
Replacing a DAP
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
