150 System configuration
Procedure 56
Enabling or re-enabling the DAPs
Step Action
1 To enable or re-enable the DAPs, power on the DAPs.
--End--
DAP manager configuration
The following procedures are described in this section.
•
“Rebooting DECT Access Points” (page 150)
•
“Adding number range” (page 151)
•
“Subscribing a DECT handset” (page 152)
Rebooting DECT Access Points
DECT Access Points need to be rebooted following software upgrades. To
reboot a DECT Access Point, complete the following procedure.
Procedure 57
Rebooting DECT Access Points
Step Action
1 Launch DAP manager by entering the following URL into an
internet browser: localhost/cds
The DAP manager IP DECT page appears.
2 Select Access Points from the menu list on the left.
The Access Points page appears information about the DAPs.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
