Troubleshooting 233
• MS windows TFTP Server (Trivial FTP daemon) is running
• dapcfg.txt and DAP firmware package are presented in the
C:\TFTPDROOT folder
If you use a built-in DHCP Server, ensure:
• the check box next to Run DHCP Server on this PC is checked
•
the DAP IP range is entered
• the DAP IP Range exclusive for DAPs only is selected
• the Subnet Mask is entered
• the Default gateway is entered
•
the TFTP IP address (of the DAP Controller PC) is entered
• the DHCP Server is running (Activate/ Deactivate/ System status
button)
If you use built-in TFTP Server (IP DECT Configurator), ensure:
•
the check box next to Run TFTP Server on this PC is checked
• 3com TFTP Server on this PC is selected
•
TFTP Server is running (Activate/ Deactivate/ System status button)
See “DHCP and TFTP servers” (page 111) for details.
If you cannot make calls from a DECT handset to an IP/TDM telephone
on the call server
Prerequisites
1.
The signaling server, call server, and DECT system are configured and
connected to the Ethernet.
2.
The DAPs are working.
If you cannot dial an IP/TDM telephone on the call server, verify the
following:
• Ensure that a dial tone sounds if a handset goes off-hook
• Ensure that the DECT handset is subscribed. For more information,
see “DAP manager configuration” (page 150).
• For DAP Manager:
— Ensure that DAPs are loaded with correct parameters (see Viewing
DAP configuration information).
• For IP DECT Configurator:
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
