System synchronization analysis 219
Step Action
1 Open the DECT manager Web interface.
2 Click Access Points.
3 Physically disconnect the DAP that you want to replace.
4 From the DAP list in DECT manager, manually record the Radio
Part Number (RPN) of the DAP you are replacing.
Wait until the status of the DAP you are replacing changes to not
working in the DECT manager Web interface.
5 In the DECT manager Web interface, select the DAP you are
removing.
6 Click Delete to delete the DAP from the system.
Wait while the system redistributes the subscription records
stored on the DAP you are removing.
The RPN of the DAP you are removing disappears from the
Subscription page in the DAP manager, and is replaced by the
RPNs of other DAPs.
7 Turn off each handset that had its subscription record stored on
the DAP you are replacing.
8 Turn on each handset that had its subscription record stored on
the DAP you are replacing.
Each handset is now connected to another DAP.
9 When you get a new DAP, ensure that the DHCP server and the
TFTP server are available in the IP network.
10 Connect the new DAP.
Wait until the new DAP appears in the DAP list of the DECT
manager.
11 In the DECT manager Web interface, click Edit.
12 In the RPN field of the new DAP, enter the RPN value you
recorded after you removed the old DAP in step 4.
13 Click OK.
The new DAP restarts. After it has restarted, verify that the new
DAP has the RPN of the DAP you removed.
--End--
System synchronization analysis
Use the information in this section to manually synchronize the DECT
system, and eliminate possible synchronization problems.
Nortel Communication Server 1000
SIP DECT Fundamentals
NN43120-123 01.07
6 January 2009
Copyright © 2008-2009 Nortel Networks
.
To Next Page
Loading...
Need help?
General
