Oki B6200 - FIP-1.P2 Blank Print (no Print)

1 - 84
Chapter 1 Troubleshooting
FIP-1.P2 Blank print (No print)
Trouble substance
The entire paper is printed pure white.
ESS and possible causative parts
- EP CARTRIDGE
- GUIDE ASSY CRU R (PL8.1.25)
- BTR ASSY (PL8.1.21)
- 150 FEEDER ASSY (PL5.1.1)
- ROS ASSY (PL8.1.1)
- PWBA ESS (PL12.1.13)
- FUSER ASSY (PL8.1.20)
- LVPS (PL12.1.5)
- HVPS/MCU (PL12.1.19)
- 250 FEEDER ASSY (PL6.1.11)
- 550 FEEDER ASSY (PL7.1.10)
Before commencing troubleshooting, check the paper transfer course. Make sure there is no foreign
articles on the transfer course, such as staples, paper clips, scraps of paper and so on.
Step Check Yes No
1
Confirm whether HVPS/MCU is
assembled under the hook of
FRAME.
Go to step 2.
Work over the
installation of
HVPS/MCU
again.
(RRP12.10)
2
Checking the laser beam course
Make sure there is no obstacle between ROS ASSY and
Drum.
Are there any obstacles on the laser beam course?
Go to step 3.
Remove
obstacles.
3
Checking ROS ASSY
Check if any obstacles entirely cover the ROS ASSY
window.
Check if the connectors of the ROS ASSY are
disconnected.
Go to step 4.
Remove
obstacles of ROS
ASSY window
and/or connect
the connectors of
ROS ASSY.
4
Checking EP CARTRIDGE
Install a new EP CARTRIDGE.
Re-print the problem image.
Is the image density normal?
End of work Go to step 5.
5
Checking BTR ASSY
Remove BTR ASSY. (RRP8.10)
Check if any stains and/or wear on BTR ASSY.
Are there any stains and/or wear on BTR?
Go to step 6.
Replace BTR
ASSY. (RRP8.10)
HOOK