Oki B6200 - FIP1.14 no Paper;Tray 1, 2

1 - 41
Chapter 1 Troubleshooting
FIP1.14 No Paper/Tray 1, 2
Step
Check Yes No
Possible causative parts:
SENSOR NO PAPER (PL5.1.38, PL6.1.38, PL7.1.38)
ACTUATOR NO PAPER (PL5.1.6, PL6.1.15, PL7.1.14)
HVPS/MCU (PL12.1.19)
LVPS (PL12.1.5)
PLATE ASSY BTM (PL2.1.10, PL3.1.10, PL4.1.10)
RACK BTM LOCK 550 (PL4.1.21)
HOUSING BASE 550(PL4.1.44)
1 Does Error Code indicate Tray 3 or Tray 4?
Go to FIP1.23 "No
Paper/Tray 3, 4".
Go to step 2.
2
Checking if there is any paper
Is there any paper in Tray 1 or Tray 2?
Go to step 3. Supply paper.
3
Is PLATE ASSY BTM (PL2.1.10, PL3.1.10. PL4.1.10) lifted
correctly?
Go to step 4.
Remove Paper
Cassette, and
then reinstall it
correctly.
4
With pressing down PLATE ASSY BTM, press the center
area of RACK BTM LOCK 550 against HOUSING BASE
550.
Are RACK BTM LOCK 550 and HOUSING BASE 550
touched each other without any space?
Go to step 5.
Work over the
installation of
RACK BTM
LOCK 550
again.(RRP4.6)
5
Checking ACTUATOR NO PAPER for operation
Remove Paper Cassette.
When putting hand from the cassette insertion space to
move ACTUATOR NO PAPER, does ACTUATOR NO
PAPER move smoothly?
Go to step 6.
Replace
ACTUATOR NO
PAPER.
6
Checking SENSOR NO PAPER for operation
Remove EP CARTRIDGE.
Does number of Sensor/Switch Check increase by one,
when ACTUATOR NO PAPER is pushed and released?.
Checks by Chapter 2 Diagnostic [Sensor/Switch Check].
Replace
HVPS/MCU.
(RRP12.10)
Go to FIP2.6
SENSOR NO
PAPER.
JG3543AA
RACKBTMLOCK550
space