3 – 198
Chapter 3 Removal and Replacement Procedures (RRPs)
RRP8.
RRP8.1 ROS ASSY (PL8.1.1)
When performing the ROS ASSY removal and/or installation, be sure to perform the
operation on a level and smooth work surface desk or the like. If the operation is
performed on a rough and/or inclined worktop, the ROS ASSY will be out of
alignment.
(34PPM)
JG3157AB
PLATE!TIE!FRONT
(PL12.1.2)
ROS!ASSY
(PL8.1.1)
CABLE!CLAMPS
DUCT!HIGH
(PL12.1.30)
To Next Page
Loading...
