Oki B6200 - Fip2.8 Sensor Toner (Pl5.1.46)

1 - 64
Chapter 1 Troubleshooting
FIP2.8 SENSOR TONER (PL5.1.46)
Step
Check Yes No
Possible causative parts:
SENSOR TONER (PL5.1.46)
SENSOR TONER ASSY (PL5.1.45)
HARNESS ASSY TONER1 (PL5.1.50)
HARNESS ASSY TONER2 (PL12.1.28)
EP CARTRIDGE
HVPS/MCU (PL12.1.19)
1
Checking EP CARTRIDGE (1)
Does sufficient toner in EP CARTRIDGE remain?
Go to step 3. Go to step 2.
2
Checking EP CARTRIDGE (2)
Does the problem still occur, after replacing EP
CARTRIDGE?
Go to step 3. End of work
3
Checking SENSOR TONER ASSY installation
Is SENSOR TONER ASSY installed correctly, and does
HOLDER-D operate smoothly?
Go to step 4.
Replace
SENSOR TONER
ASSY.
4
Checking HARNESS ASSY TONER1 for continuity
Remove HARNESS ASSY TONER1.
Is J220 <=> J221 continuous normally?
Go to step 5.
Replace
HARNESS ASSY
TONER1.
5
Checking HARNESS ASSY TONER2 for continuity
Remove HARNESS ASSY TONER2.
Is J22 <=> J221 continuous normally?
Go to step 6.
Replace
HARNESS ASSY
TONER2.
6
Checking SENSOR TONER
Replace SENSOR TONER. (RRP5.9)
Does the problem still occur, after replacement?
Replace
HVPS/MCU.
(RRP12.10)
End of work