5 – 1
Chapter 5 Parts List(24PPM)
1. Parts List
1.1 Caution for use of parts list
The figures indicating the illustrations are the item No. in the list and present correspondence
between the illustrations and parts.
The notation of PL "X.Y.Z" is composed of the plate (PL), item "X.Y", and parts "Z".
The alphabet characters in the illustrations represent screws and clips as follows:
"S": screw, "E": E-ring, "KL": KL clip, "C": C-ring, and "N": nut
"t" mark in the illustrations are attached to items indicating assembly parts in the illustrations.
Encircled alphabetical figures in the illustrations indicate interrupted leader lines. Same characters
in the illustrations represent lines to be connected.
The mark "(with 2-5)" attached to assembly parts on the illustrations and lists represents that the
items "2, 3, 4, and 5" of that plate are contained and the mark "(with 2-5, PL6.1.1.1) represent that
the item "2, 3, 4, and 5" of that plate and the item "1" of the plate "6.1" are contained.
The mark "[Same PLX.Y.Z]" attached to parts in the illustrations and lists resents that the parts is the
same as the parts of the item "Z" of the plate "X.Y".
The mark "H" attached to the item in the list represents "recommended spare parts" which can be
usually supplied. (Supply of other parts shall be examined separately.)
The mark "[" attached to parts in the list represents "Note" or "Reference" about that parts is con-
tained in the same page.
"HIGH ASSY" in the list represent the high level assembly parts containing that parts.
For spare parts, refer to the Spare parts list which is issued separately.
For the connector (P/J), parts such as harness, wire, etc. in the list, refer to Chapter
6, Electric wiring
It should be noted that configuration of parts may be different or some parts are
not used depending on specifications of OEM.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
