1 - 39
Chapter 1 Troubleshooting
FIP1.12 Paper Size Error
Step
Check Yes No
Possible causative parts:
150 FEEDER ASSY (PL5.1.1)
150 PAPER CASSETTE (PL2.1.50)
SENSOR REGI (PL5.1.30)
ACTUATOR B (PL5.1.17)
HVPS/MCU (PL12.1.19)
GUIDE TRAY LEFT (PL7.1.7)
250 FEEDER ASSY (PL6.1.11)
250 PAPER CASSETTE (PL3.1.50)
550 FEEDER ASSY (PL7.1.10)
550 PAPER CASSETTE (PL4.1.50)
1
Checking the paper size setup
Does the paper size in use match the size setup by GUIDE
ASSY END or by the driver on the PC?
Go to step 2.
Replace the
paper, or change
the paper size
setting.
2
Checking NVRAM data
Does 740-002 Configuration 2 meet the specifications?
Go to step 3.
Modify the
memory data.
3
Checking Regi Sensor
Remove EP CARTRIDGE.
Keep the lever of INTERLOCK S/W pushed as opening
COVER OPEN (PL1.1.2).
Does the number of Sensor/Switch Check increase one by
one, when ACTUATOR B of SENSOR REGI is pushed and
released?
Checks by Chapter 2 Diagnostic [DC330 Component
Control].
Go to step 4.
Go to FIP2.5
SENSOR REGI.
4
Checking the paper feeding tray
Is the paper supplied from Tray 1 or Tray 2, when Error is
occurred?
Go to step 5. Go to step 6.
5
Checking Paper Cassette (1)
Are GUIDE ASSY END, GEAR SECTOR, RACK SIZE,
LINK SW SIZE1/2/3 of Paper Cassette of Tray 1 or Tray 2
installed correctly?
Go to FIP2.17
GUIDE TRAY
LEFT.
Reinstall the parts
causing Error.
6
Checking the paper tray
Is the paper supplied from Tray 3 or Tray 4 when Error is
occurred?
Go to step 7.
Replace
HVPS/MCU.
(RRP12.10)
7
Checking Paper Cassette (2)
Are GUIDE ASSY END, GEAR SECTOR, RACK SIZE,
LINK SW SIZE1/2/3 of Paper Cassette of Tray 3 or Tray 4
installed correctly?
Go to FIP2.24
OPT ASSY SIZE.
Reinstall the parts
causing Error.
To Next Page
Loading...
