Oki B6200 - FIP-1.P1 Faint Print (Low Contrast); Image Quality FIP

1 - 82
Chapter 1 Troubleshooting
5.2 Image Quality FIP
FIP-1.P1 Faint print (Low contrast)
Trouble substance
The density of the image is entirely too faint.
ESS and possible causative parts
- EP CARTRIDGE
- GUIDE ASSY CRU R (PL8.1.25)
- BTR ASSY (PL8.1.21)
- 150 FEEDER ASSY (PL5.1.1)
- PWBA ESS (PL12.1.13)
- ROS ASSY (PL8.1.1)
- FUSER ASSY (PL8.1.20)
- LVPS (PL12.1.5)
- HVPS/MCU (PL12.1.19)
- 250 FEEDER ASSY (PL6.1.11)
- 550 FEEDER ASSY (PL7.1.10)
Before commencing troubleshooting, check the paper transfer course. Make sure there is no foreign
articles on the transfer course, such as staples, paper clips, scraps of paper and so on.
Step Check Yes No
1
Checking the paper condition
Have new, dry and recommended paper on, and operate
Test Print.
Is the density of the image normal?
End of work Go to step 2.
2
Checking the laser beam course
Make sure there is no obstacle between ROS ASSY and
Drum.
Check if any stains on ROS ASSY window.
Are there any obstacles on the laser beam course?
Is ROS ASSY window clean?
Go to step 3.
Remove
obstacles and/or
clean ROS ASSY
window.
3
Checking EP CARTRIDGE
Install a new EP CARTRIDGE.
Re-print the problem image.
Is the image density normal?
End of work Go to step 4.
4
Checking BTR ASSY
Remove BTR ASSY. (RRP8.10)
Check if any stains and/or wear on BTR ASSY.
Are there any stains and/or wear on BTR?
Go to step 5.
Replace BTR
ASSY. (RRP8.10)
5
Checking the drum ground
Remove GUIDE ASSY CRU R. (RRP8.13)
Check the Plate Earth, located on the back of GUIDE
ASSY CRU R.
Is the Plate Earth stained and/or deformed?
Go to step 6.
Reform or clean
the Plate Earth, or
replace GUIDE
ASSYCRU R.
(RRP8.13)