1 - 35
Chapter 1 Troubleshooting
FIP1.10 Paper Jam/Misfeed
Step
Check Yes No
Possible causative parts:
150 FEEDER ASSY (PL5.1.1)
150 PAPER CASSETTE (PL2.1.50)
SENSOR REGI (PL5.1.30)
ACTUATOR B (PL5.1.17)
LVPS (PL12.1.5)
HVPS/MCU (PL12.1.19)
CLUTCH REGI (PL5.1.23)
CHUTE ASSY FDR1 (PL5.1.3)
GEAR ASSY HOUSING (PL11.1.3)
SENSOR NO PAPER (PL5.1.38, PL6.1.38, PL7.1.38,
PL20.2.33)
CHUTE ASSY FDR2 (PL6.1.22, PL7.1.21, PL20.2.2)
PLATE ASSY BTM (PL2.1.10, PL3.1.10, PL4.1.10,
PL20.3.10)
ROLL ASSY RETARD (PL2.1.2, PL3.1.2, PL4.1.2,
PL20.3.2)
CLUTCH ASSY PH (PL5.1.21, PL6.1.21, PL7.1.20,
PL20.2.21)
ROLL ASSY TURN (PL20.2.14)
CLUTCH PR-REGI (PL20.2.22)
250 FEEDER ASSY (PL6.1.11)
250 PAPER CASSETTE (PL3.1.50)
550 FEEDER ASSY (PL7.1.10)
550 PAPER CASSETTE (PL4.1.50)
1
Does Error still occur, after removing all the jamming paper
from the feeding tray?
Go to step 2.
Go to FIP1.14
Paper out / Tray
1, 2.
2
Checking paper condition
Is the paper curled, damaged or damp?
Replace the
paper with a new
and dry one
Go to step 3.
3
Checking the paper size setup
Does the paper size in use match the size setup by GUIDE
ASSY END or by the driver on the PC?
Go to step 4.
Replace the
paper, or set up
the paper size
correctly.
4
Checking PLATE ASSY BTM for operation
Is PLATE ASSY BTM pushed up, and moved up and down
smoothly, when installing Paper Cassette?
Remove Paper Cassette.
Check if PLATE ASSY BTM is pushed up, while installing
Paper Cassette.
Push PLATE ASSY BTM down and release, and check the
movement.
Check visually if PLATE ASSY BTM is incline to right or
left.
Go to step 5.
Replace PLATE
ASSY BTM.
(RRP2.5, 3.5, 4.5,
20.21)
To Next Page
Loading...
